Troubleshooting and tips
Acoustic warnings
Acousticerror messagesErrors
Cause
Troubleshooting
A beep sounds every few seconds.
The battery is a lmost flat.
► Ch arge the battery.
Error messages on the screen
Errormess agesonthe sc
reen
Errormessage:
This section describes the e rror messages generated by the BIOS Setup. Error messages displayed
by the operating system or programmes are described in the relevant documentation.
If the error message appears repeatedly, despite troubleshooting measures, please
contact the place of purchase or our customer service centre.
Error message/cause Resolution
CMOS battery bad
If the error message occu rs repeatedly, the
buffer battery in the notebook is flat.
► Contact your sales outlet or our customer
service centre.
System CMOS checksum bad - default configuration
used
The system configuration information is
incorrect.
► Switch the notebook off.
► Switch the notebook on.
► Pre ss the function key
F2
to access the
BIOS Setup.
► In the BIOS Setup, select the Exit menu.
► Select the entry Load Setup Defaults.
► Select OK and press the Enter key.
Extended memory failed at o ffset: xxxx Failing Bits:
zzzz zzzz
When testing the extended m emory an error has
resulted at the address xxxx.
► Check wh ethe
r the additional memory
module has be
en inserted correctly.
Failure Fixed Disk n
The s ettings of the hard disk drive are incorrect.
► Start the B
IOS Setup (Primary Master
submenu)
and select the correct settings.
Keyboard controller error
► Switch t
he notebook off with the ON/OFF
switch.
► Wait 3 - 5 seconds and switch on the
notebook again.
Keyboard error
If you are using an external keyboard:
► Ch eck the connection and reboot the
notebook.
nn Stuck key
► Make sure that no key is pressed.
78 Fujitsu Technology Solutions
To Next Page
Loading...
Need help?
General