Manufacturer’s notes
Radio frequencies used
RF m odu le Frequency band Max. transmission po w e r
1 BT 2400-2480 MHz 100 mW
2
NFC
13.56 MHz 20 mW
3 WLAN 2410-2480 MHz 100 mW
4 WLAN 5150-5350 MHz class 2 200 mW
5
WLAN 5470-5725 MHz c lass 1 1 W
6
GSM
850 MHz, 900 MHz 2 W
7
UMTS
1900 MHz, 1800 MHz 500 mW
8 LTE 2100 MHz, 2600 MHz 500 mW
9 LTE 850 MHz, 90 0 MHz 2 W
Other certification marking s
Certificationmarkings
Any other certification markings are listed in the "Manual Appendix -
Additional Certifications" supplement.
If such markings a re available, you can fin d the supplement on the Internet at
"
http://support.ts.fujitsu.com/Ma nuals/" with the Operating Manual for your device.
Regulatory notices
If there is no FCC logo and also no FCC ID on the device then this device is
not approved by the Federal Communications Commission (FCC) of the USA.
Although it is not explicitly forbidden to travel in the US trading area carrying this
device, to avoid trouble at customs clearan ce, Fujitsu Technology Solutions GmbH
recommends not to bring this device into the US trading area.
Regulatory information for Tablet PCs without radio device
Regulatoryinformation
NOTICE:
Changes or modifications not exp ressly a pproved by F ujitsu Technology Solutions
could void this user’s authority to operate the equipment.
Notice to Users of Radios and Television
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordan ce with th e instructions, may cause harmful interfe rence
to radio communica tions. However, there is no guarantee th at interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following m easures:
• Reorient or relocate the receiving ant enna.
• Increase the sep aration between the eq uipm ent and receiver.
Fujitsu 77
To Next Page
Loading...
Need help?
General