12
ADJUSTMENTS
This section provides the procedures for initial set up of the equipment. The type of trans-
ducer used should be properly set before operating the equipment.
3.1 System Menu
Initial settings are made on SYSTEM menu. Open the menu as follows.
1. Press the [PWR] key while pressing and holding down any key.
[SYSTEM MENU]
LANGUAGE
FUNCTION SETTING
NAV DATA SETTING (NMEA)
SCREEN ADJUSTMENT
USER COLOR SETTING
TRANSDUCER SETTING*
DRAFT ADJUSTMENT
DEMO MODE SETTING
TEST
TEST PATTERN
TARGET ECHO
FACTORY SETTING
[▲] [▼] : Select item.
[MENU] : Open menu.
Turn off power to activate settings.
*Not available on FCV-1500M.
Figure 3-1 SYSTEM menu
2. Select menu with the [▲]/[▼] key. The selected item is highlighted in green.
3. Press the [MENU] key to open menu selected.
4. Select item with the [▲]/[▼] key. The selected item is highlighted in green.
5. Select option with the [t]/[s] key, or set value with the [+]/[-] key. The selected option
is highlighted in white.
6. Press the [MENU] key to close the menu and return to the SYSTEM menu.
7. To escape from the SYSTEM menu turn off the power, and wait a few seconds and
then the power on again. (This must be done when changing the language.)
To Next Page
Loading...
