5-3
5.2 Calling a Station
1. Press function key [F3] to display the Operate menu.
1: Call Station
2: Macro Operation
3: File to Send
4: Cancel Sending
5: Scan (Start/Stop)
6: Manual Reception
7: Timer Operation
8: High Tension ON
9: Manual Calling
0: Set Frequency
Operate
Figure 5-4 Operate menu
2. Press the [1] key to display the Station List.
3. Select the station you wish to call.
4. Press the [Enter] key to establish connection with the station.
Station Name : CHOUSHI-8M
Frequency (T/R) : 8765.00 / 8965.00(kHz) Comm Mode :ARQ
Comm Status : Connect Send Lock Error
Sending Volume : 100(%) ARQ Error : 0 ARQ Time : 0(sec)
Caps
1:File 2:Edit 3:Operate 4:Window 5:Station 6:System 7:WRU 8:HR 9:Over 10:Break
1996-11-15 14:28 (JST)
Figure 5-5 Communication status display
"Connect" appears in inverse video on the Comm Status line when
an acknowledge signal from the station called is detected. (In the
ARQ mode connection may be delayed due to signal condition. In
the FEC mode, however, "Connect" appears in inverse video a few
seconds later since the acknowledge signal is not required.)
To Next Page
Need help?
General
