6-1
DISTRESS ALERT
Preparing a Distress Alert
1. Press [F8] to display the Setup menu. Note that this key has pre-
cedence over any operation.
2. Press [1] to display the Distress Message Setup screen.
Distress Alert Setup
LES ID
Update Time
Position
Protocol
Nature
Course
Speed
144
06:23 97-08-20 (YY-MM-DD)
LAT 35:00N
LON 135:00E
Maritime
Undersignated
187
10 KTS
Figure 6-1 Distress Alert setup screen
3. The default LES ID is 144, AOR-E, NCS. To change, press [En-
ter] to display the LES ID list. Select a suitable LES and press
[Enter].
4. Press [
/
] to select Update Time. Enter the time (hours and min-
utes and date) if necessary. The time indication stays still show-
ing the last update. Current time and position are shown at the
bottom right on the screen.
5. Press [
/
] to select Position.
6. Press [Enter] to open the window for position entry.
7. Enter position in latitude and longitude. Use [
] to shift the cur-
sor from degree to minutes and co-ordinate. Enter co-ordinate with
appropriate alphabet key.
8. Press [Enter] to close the window.
9. Press [
/
] to advance the cursor to the Protocol line.
10.For marine vessels Protocol should be set to Maritime.
To Next Page
Loading...
Need help?
General
