190-02692-00 Rev. A
Garmin G1000 Pilot’s Guide for the Piper PA-32 Saratoga
255
FLIGHT MANAGEMENT
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
Selecting automatic or manual page mode:
From the AUX – TRIP PLANNING Page, press the AUTO Softkey or the MANUAL Softkey; or press the MENU
Key, highlight ‘Auto Mode’ or ‘Manual Mode’, and press the ENT Key.
Selecting flight plan or waypoint mode:
From the AUX – TRIP PLANNING Page, press the FPL Softkey or the WPTS Softkey; or press the MENU Key,
highlight ‘Flight Plan Mode’ or ‘Waypoints Mode’, and press the ENT Key.
Selecting a flight plan and leg for trip statistics:
1) From the AUX – TRIP PLANNING Page, push the FMS Knob to activate the cursor in the flight plan number field.
2) Turn the small FMS Knob to select the desired flight plan number.
3) Turn the large FMS Knob to highlight CUM or REM. The statistics for each leg can be viewed by turning the
small FMS Knob to select the desired leg. The Inset Map also displays the selected data.
Selecting waypoints for waypoint mode:
1) From the AUX – TRIP PLANNING Page, press the WPTS Softkey; or press the MENU Key, highlight ‘Waypoints
Mode’, and press the ENT Key. The cursor is positioned in the waypoint field directly below the FPL Field.
2) Turn the FMS knobs to select the desired waypoint (or select from the Page Menu ‘Set WPT to Present Position’
if that is what is desired), and press the ENT Key. The cursor moves to the second waypoint field.
3) Turn the FMS knobs to select the desired waypoint, and press the ENT Key. The statistics for the selected leg
are displayed.
In manual page mode, the other eight trip input data fields must be entered by the pilot, in addition to flight
plan and leg selection.
Entering manual data for trip statistics calculations:
1) From the AUX – TRIP PLANNING Page, press the MANUAL Softkey or select ‘Manual Mode’ from the Page
Menu, and press the ENT Key. The cursor may now be positioned in any field in the top right two boxes.
2) Turn the FMS Knobs to move the cursor onto the DEP TIME Field and enter the desired value. Press the ENT
Key. The statistics are calculated using the new value and the cursor moves to the next entry field. Repeat until
all desired values have been entered.
To Next Page
Loading...
Need help?
General
