190-02692-00 Rev. A
Garmin G1000 Pilot’s Guide for the Piper PA-32 Saratoga
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
433
APPENDIX B
5) Press the YES softkey. The navigation database is copied to the SD card in the bottom of the display.
6) After the navigation database files are copied to the bottom SD card, the display will appear.
Figure B-6 Standby Navigation Database Update Complete
7) As instructed on the display, press any key to continue. The display will now appear.
Figure B-7 Navigation Database Verification Prompt
8) Press any key to continue. The display will now appear.
Figure B-8 Active Navigation Database Prompt
9) Press the NO Softkey. The display now starts in normal mode. Since the database effective date is not yet valid,
it should not be loaded as the active database. Do not remove power while the display is starting.
10) Turn the system OFF and remove the SD card from the top card slot.
11) Repeat steps 2 through 10 for the other display(s).
12) Apply power to the system and press the ENT Key on the MFD display to acknowledge the startup screen.
13) Turn the large FMS Knob to select the AUX Page group on the MFD.
14) Turn the small FMS Knob to select the System Status Page.
15) Press the Display Database Selection Softkey to show standby navigation database information for each display.
To Next Page
Loading...
Need help?
General
