190-02692-00 Rev. A
Garmin G1000 Pilot’s Guide for the Piper PA-32 Saratoga
27
SYSTEM OVERVIEW
SYSTEM
OVERVIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO PANEL
& CNS
FLIGHT
MANAGEMENT
HAZARD
AVOIDANCE
AFCS
ADDITIONAL
FEATURES
APPENDICES INDEX
Pilot Profiles
System settings may be saved under a pilot profile. Each time the system is powered on, the last selected
pilot profile is shown on the MFD Start-up Screen. The system can store up to 25 profiles. The currently
active profile, the amount of memory used, and the amount of memory available are shown at the top of the
AUX – SYSTEM SETUP Page in the box labeled PILOT PROFILE. From here, pilot profiles may be created,
selected, renamed, or deleted.
Figure 1-17 Pilot Profile Settings on AUX – SYSTEM SETUP Page
Creating a profile:
1) Use the FMS Knob to select the AUX – SYSTEM SETUP Page.
2) Push the FMS Knob to activate the flashing cursor.
3) Turn the large FMS Knob to highlight ‘CREATE’ in the PILOT PROFILE Box.
4) Press the ENT Key. A CREATE PROFILE Window is displayed.
5) Use the FMS Knob to enter a profile name up to 16 characters long and press the ENT Key. Pilot profile names
cannot begin with a blank as the first letter.
6) In the next field, turn the small FMS Knob to select the desired settings upon which to base the new profile.
Profiles can be created based on Garmin factory defaults, default profile settings (initially based on Garmin
factory defaults unless edited by the pilot), or current system settings.
To Next Page
Loading...
Need help?
General
