GE AKTA pilot 600 User Manual

3.6 Air trap valve and air trap
Introduction
This section describes the air trap valve and the air trap. For information on how to fill
and empty the air trap, see the ÄKTA pilot 600 Operating Instructions.
The purpose of the air trap is to trap air that has been introduced into the flow path. The
purpose of the air sensor in the air trap valve is to detect and report all air in the flow
path. Air reaching the column could decrease the column performance.
Illustration
The illustration below shows the front of the air trap valve module (left) and the air trap
(right).
1
2 3
4
5
6
78910
DescriptionPart
Inlet, from the previous module1
ÄKTA pilot 600 User Manual 29274559 AA 41
3 Description of modules
3.6 Air trap valve and air trap

GE AKTA pilot 600 Specifications

General

Brand	GE
Model	AKTA pilot 600
Category	Laboratory Equipment
Language	English