GE AKTA pilot 600 User Manual

3.9 Conductivity monitor
Introduction
This section describes the conductivity monitor modules:
•
Pre-column conductivity monitor (optional)
•
Conductivity monitor (always installed in the system)
The purpose of these monitors is to continuously measure the conductivity of samples
and buffers in the flow path.
Illustration
The illustration below shows the front of the conductivity monitor modules. The two
modules are physically identical.
Pre-column
1 2
3 4
DescriptionPart
Inlet/outlet1 to 4
Function
The conductivity monitors can be used together with watch functions in UNICORN to
control different steps in a chromatography or preparation run.
The individual cell constant for each monitor is calibrated on delivery but can be re-cal-
ibrated if needed, see Section 5.4.2 Calibrate the conductivity monitor, on page 104.
ÄKTA pilot 600 User Manual 29274559 AA 51
3 Description of modules
3.9 Conductivity monitor

GE AKTA pilot 600 Specifications

General

Brand	GE
Model	AKTA pilot 600
Category	Laboratory Equipment
Language	English