4.5 Power supply
Introduction
This section gives an overview of the power requirements for ÄKTAprocess. This includes
a description of the various circuit breakers.
Power requirements
The power supply requirements are specified in Section 8.1 Specifications, on page 164.
WARNING
Protective ground. ÄKTAprocess must always be connected to a
grounded power outlet.
WARNING
National Codes and standards (NEC, VDE, BSI, IEC, UL etc.) and local
codes outline provisions for safely installing electrical equipment.
Installation must comply with specifications regarding wire types,
conductor sizes, plug, branch circuit protection and disconnect
devices. Failure to do so may result in personal injury and/or
equipment damage.
WARNING
All electrical installations must be performed by authorized
personnel only.
Installation
The system power cord is connected in one of the following ways:
•
A fixed power supply by means of a permanent connection with a safety switch (UL
or CE classified systems)
•
A connector compliant with IEC 60309-2 (CE classified systems only)
ÄKTAprocess Operating Instructions 29-0252-49 AA 105
4 Installation
4.5 Power supply
To Next Page
Loading...
Need help?
General
