GE AKTAprocess User Manual

3.3.2 Control system components
Introduction
This section describes the components that allow automation of ÄKTAprocess by the
UNICORN control system.
Control system
ÄKTAprocess is fully automated by means of the UNICORN control system. Once the re-
quired methods are created and approved, a non-expert user can safely operate the
system.
Refer to Section3.6 UNICORN control system, on page77 for information on the UNICORN
control system.
Control unit
A CU-960 control unit is the controlling interface between UNICORN and the components
of ÄKTAprocess.
The CU-960 control unit is located inside the cabinet.
Computer
The computer is built into the cabinet and fully protected from the outside environment.
User console
The display and input equipment is ergonomically designed for usage in a clean produc-
tion environment.
ÄKTAprocess Operating Instructions 29-0252-49 AA 55
3 System description
3.3 Standard components
3.3.2 Control system components

GE AKTAprocess Specifications

General

Brand	GE
Model	AKTAprocess
Category	Laboratory Equipment
Language	English