Chapter 4. Measuring Thickness
DM5E Operating Manual 35
Chapter 4. Measuring Thickness
After setting up the instrument as described in Chapter 3, additional adjustments can be made by selecting the type of measurement made
and the way in which it is displayed. You will also find information related to configuring and working with the BSCAN mode. The specific
topics include how to:
• Select the measured value to view (see Section 4.1 on page 36)
• Work with Normal measurement mode (see Section 4.2 on page 39)
• Use the Min Scan and Max Scan measurement modes (see Section 4.3 on page 40)
• Interpret the Differential/Rate-of-Reduction measurement mode (see Section 4.4 on page 41)
• Work with the B-Scan measurement mode (see Section 4.5 on page 42)
• Use the Dual Multi measurement mode (see Section 4.6 on page 43)
Note: Load a Setup file corresponding to the connected probe prior to making the adjustments described in this chapter. Loading a Setup
file after these adjustments are made will force certain settings back to the default value stored in the file.
To Next Page
Loading...
Need help?
General
