Chapter 2: Operation
Page 28 HygroPro User’s Manual
2.2.5 Setting Up the Analog Output (cont.)
In the Output menu, select Trim and press enter. The following
screen appears:
Enter your values for the
Base Trim,
Span Trim and %, using the same
procedures as on the previous page.
When you select the Mode option at the above prompt, choose either
Test to verify the output or Normal for normal operation.
2.2.6 Entering the Node ID
The Node ID is a unique network identifier that enables the HygroPro
to be connected to a multi-drop network when used with PanaView™
interface software. To enter your Node ID, proceed as follows:
Enter your passcode to access the setup
program. Then use the arrow keys to
select the Node ID menu. Press enter.
Use the arrow keys to enter the desired
Node ID value and press enter.
To Next Page
Loading...
Need help?
General
