APPENDIX I — 269 Commissioning Summary 269.D6.0.4
I-1
PAGE 1: SETPOINT VALUES
MOTOR AMPS SETPOINTS
PAGE 2: SETPOINT VALUES
RTD SETPOINTS
PAGE 3: SETPOINT VALUES
O/L CURVE SETPOINTS
PAGE 4: SETPOINT VALUES
RELAY CONFIGURATION
Phase CT Secondary RTD Type Message
2
Curve Number O/L Trip
Phase CT Primary Any RTDs Connected?
3
U/B Trip
Motor FLC (amps) RTD Message Display S/C Trip
O/L Pickup Level (%) # of Stator RTDs used U/C Trip
Accel. Time (secs)
RTD 1 Alarm Level (°C)
Rapid Trip
Starts/Hour
RTD 1 Trip Level (°C)
Stator RTD Trip
U/B Alarm Level (%)
RTD 2 Alarm Level (°C)
RTD Trip
U/B Alarm Delay (secs)
RTD 2 Trip Level (°C)
G/F Trip
U/B Trip Level (%)
RTD 3 Alarm Level (°C)
Accel. Time Trip
U/B Trip Delay (secs)
RTD 3 Trip Level (°C)
Phase Rev. Trip
G/F C.T. Ratio :5?
RTD 4 Alarm Level (°C)
Inhibit Lockouts
(NO indicates 2000:1)
RTD 4 Trip Level (°C)
Single Phase Trip
G/F CT Primary
1
RTD 5 Alarm Level (°C)
U/V Trip
G/F Alarm Level (amps)
RTD 5 Trip Level (°C)
O/V Trip
G/F Alarm Delay (secs)
RTD 6 Alarm Level (°C)
PF Trip
G/F Trip Level (amps)
RTD 6 Trip Level (°C)
O/L Warning
G/F Trip Delay (secs)
RTD 7 Alarm Level (°C)
G/F Alarm
U/C Alarm Level (amps)
RTD 7 Trip Level (°C)
U/B Alarm
U/C Alarm Delay (secs)
RTD 8 Alarm Level (°C)
U/C Alarm
U/C Trip Level (amps)
RTD 8 Trip Level (°C)
Mechanical Jam Alarm
U/C Trip Delay (secs) Stator RTD Alarm
Mech Jam Alarm (xFLC) RTD Alarm
Mech Jam Alarm Del. (s) No Sensor Alarm
Rapid Trip (× FLC) Low Temp. Alarm
Rapid Trip Delay (secs) TC Alarm
S/C Trip Level (×FLC) U/V Alarm
S/C Trip Delay (secs) O/V Alarm
Immediate O/L (× FLC) PF Alarm
KVAR Alarm
1
Not seen if ratio is 2000:1
2
Not a setpoint Meter Alarm
3
If answer is NO, all RTD setpoints Self-Test Fail
on all pages are not seen
NOTE: Shaded setpoints in commissioning summary have
been added or altered as compared to last revision
To Next Page
Loading...
Need help?
General
