Installation
Lifting and positioning the pole
GE Information08- 2016 L31- 200EN/07
3/4
Positioning the pole
Process
The table below gives the steps of positioning the pole :
Step Action
1 Use a lifting device to position the chassis frame onto its ground
attachment points but do not secure it
, whilst respecting the orient-
ation of the pole indicated on the sketch of the device
.
2 If necessary, place shims under the supports of the frame so that
the upper plate is level.
3 Install the washers (12) and clamp the whole to the ground using
nut.
4 Remove the lifting straps.
5
18 daN.m
Check the tightening torques of all frame screws.
6 T ighten the fixings on the two floor seatings in accordance with the
module entitled ’Tightening Torques’ and in accordance with the
diameters of the anchoring points.
12
To Next Page
Loading...
Need help?
General
