○○○○○○○○○○○○○
Sounds & Performances 37
○○○○○○○○○○○○○
6) Modify the effects.
The ON/OFF status of the REVERB and CHORUS functions, the corresponding effect types and the rela-
tive general effect volume setting to associate to the current Performance can be memorized.
7) When the track is enabled (flashing), it is possible to modify all the associated parameters. Use the
PAGE [ ] and [ ] buttons to gain access to the following parameters;
THE PERFORMANCE PARAMETERS
- VOLUME : (00/127) determines the track volume level.
- REVSEND: (00/15) the value determines the amount of Reverb effect applied to the track.
- CHOSEND: (00/15) the value determines the amount of Chorus effect (modulation/delays) applied to the
track.
- TRANSP: (-24/+24) determines the transposition (up or down) to apply to the track.
- DETUNE: (-63/+63) determines the fine tuning to apply to the track. Each step is equivalent to 1/64th of
a semitone.
- PAN : 00/31 right, 00 centre, 00/-31 left) determines the position of the sound within the stereo panorama
(left, right or centre).
An anti-clockwise rotation of the Dial [Tempo/Data – button of PK5] sets the PAN to mute; in this situation
the sound is not delivered either left or right; if the effects are active on the track, you will only hear the
processed sound.
In the case of a Drumkit (which contains incorporated pan settings), the display will show the ‘PAN lock’
setting: in this case, PAN will be deactivated for the Drumkit.
- VOL_PED: (ON/OFF) enables or disables the track for the action of the optional Volume Pedal (con-
nected to the rear panel jack).
- DAMPER: (ON/OFF) enables or disables the track for the action of the optional Damper pedal (sustain
effect).
To Next Page
Loading...
Need help?
General
