78
5 MAINTENANCE, CLEANING, LUBRICATION
5.1 ENGINE
Refer to engine instruction manual.
5.2 GREASE NIPPLES
For RS/R (steering wheel) models
Every 50-60 hours, grease the following points:
3 Fig.13 Axle ball-joint
1 Fig.13 Front wheel ball-joints (upper and lower)
It is advisable to use AGIP GREASE LP2
For SN/A (articulated) models
Every 50-60 hours, grease the following points:
1 Fig.14 Axle ball-joint
It is advisable to use AGIP GREASE LP2
5.3 FILLING WITH OIL
5.3.1 Gearbox casing - differential and hydraulic lift
Every 50 hours check the oil level with plug 4 Fig.13-14
It is advisable to use AGIP SUPER TRACTOR UNIVERSAL SAE 15W/40 oil.
Thereafter change the oil every 800 hours (plug 4, Fig. 13-14).
Quantity needed: about 18 kg.
Oil drain: plug 1 Fig.15.
5.3.1.1 Cleaning lift oil filter
Clean this filter every 400 hours and each time the oil is changed. Once the oil
has been drained out, remove the filter (3 Fig.12), wash it with petrol or diesel,
dry it and replace in its seating. Clean the filter after the first 50 hours.
5.3.2 Front axle
Every 50 hours, check oil level through plug 2, Fig. 13-14
It is advisable to use AGIP ROTRA MP SAE 80W/90 oil.
Thereafter change the oil every 800 hours (plug 2, Fig. 13-14).
Quantity needed: about 9.5 kg.
Oil drain: plug 6 Fig.13-14.
5.3.3 Final drives
Check the oil level in the front and rear final drives on a regular basis. Remove
the plugs (7, Fig. 13-14). The oil must come up to the bottom line of the hole.
It is advisable to use AGIP ROTRA MP SAE 80W/90 oil.
To Next Page
Loading...
Need help?
General