Graco Magnum ProX7 User Manual

Getting Started With Basic Techniques
14 312001B
Getting Started With Basic Techniques
Use the Practice Spray Board to practice these basic spraying techniques before you begin spraying the surface.
• Hold gun 12 in. (30 cm) from surface and aim
straight at surface. Tilting gun to direct spray angle
causes an uneven finish.
• Flex wrist to keep gun pointed straight. Fanning gun
to direct spray at angle causes uneven finish.
Triggering Gun
Pull trigger after starting stroke. Release trigger before
end of stroke. Gun must be moving when trigger is
pulled and released.
Aiming Gun
Aim tip of gun at bottom edge of previous stroke, over-
lapping each stroke by half.
Spray Shield
Use Sample Spray Shield to help shield ceilings and floor
boards from spray. The Sample Spray Shield is intended
to introduce you to the benefits of a spray shield. Visit
your local paint supplier for larger spray shield solutions.
1. Apply a layer of masking tape
approximately 4 inches wide to
edge of spray shield. Change tape
when paint starts to accumulate
on spray shield.
2. Grasp shield firmly through han-
dle grip with one hand.
3. When spraying, use shield
to prevent paint from getting
on ceiling or adjoining walls.
4. Move the spray shield as
you move the gun to protect
surface.
TIA
12 in.
(30 cm)
even
finish
thick
thin
uneven
finish
TIA
even finish thin thick thin
TIA
TIA
tape
ti9313a
ti9573a

Graco Magnum ProX7 Specifications

General

Brand	Graco
Model	Magnum ProX7
Category	Paint Sprayer
Language	English