Graco Magnum ProX7 User Manual

Shutdown and Cleaning
312001B 17
Power Flush
Power flushing is a faster method of flushing. It can only
be used after spraying water-based coatings.
1. Relieve pressure, page 8.
2. Remove tip and guard assembly from gun and place
in waste pail.
3. Place waste and paint pails
side by side.
4. Lift suction tube and prime tube from paint pail. Let
them drain into paint for a while.
5. Place suction and prime tube in waste pail.
6. Turn Pressure Control knob to
the Prime/Clean setting.
7. Screw power flush attachment
to garden hose. Close valve.
8. Turn on water. Open valve.
Rinse paint off suction tube,
prime tube and inlet screen.
9. Turn lever to close power flush
attachment.
10. Unscrew inlet screen from suction
tube. Place inlet screen in waste pail.
11. Connect garden hose to suction tube
with Power Flush attachment. Leave
prime tube in waste pail.
12. Turn power switch ON.
13. Open lever on Power Flush
attachment.
14. Circulate water through sprayer, into waste pail, for
20 seconds.
15. Turn power switch OFF.
ti9726a
ti9344
ti9413a
ti9727a
TIA
TIA
TIA
TIA
OPEN
WLD

Graco Magnum ProX7 Specifications

General

Brand	Graco
Model	Magnum ProX7
Category	Paint Sprayer
Language	English