Storage
20 312001B
Storage
Short Term Storage
(up to 2 days)
1. Relieve pressure, page 8.
2. Place suction tube and prime
tube in paint pail.
3. Cover paint pail and hoses
tightly with plastic wrap.
4.
a. Engage trigger lock.
b. Leave gun attached to hose.
c. If you have not already
cleaned them, remove tip
and guard from gun and
clean with water or flushing
solvent. A soft brush can be
used to loosen and remove
dried on material if needed.
d. Wipe paint off outside of gun using a soft cloth
moistened with water or flushing solvent.
Long Term Storage
(more than 2 days)
1. Place suction tube in
Pump Armor storage fluid
bottle and prime tube in
waste pail.
2. Turn Prime/Spray valve to
PRIME.
3. Turn power switch ON.
4. Turn pressure control knob
clockwise until the pump turns
on.
5. When storage fluid comes out
of prime tube (5-10 seconds)
turn power switch OFF.
6. Turn Prime/Spray valve to
SPRAY to keep storage fluid
in sprayer during storage.
ti9353a
ti9350a
ti8908a
ti9671a
• Always circulate Pump Armor storage fluid
through system after cleaning. Water left in
sprayer will corrode and damage pump.
• Follow Shutdown and Cleaning, page 15.
TIA
ti9346a
TIA
ti9343a
WLD
ti9345a
To Next Page
Loading...
Need help?
General
