Setup
312001B 9
Setup
1. Unscrew tip and guard assem-
bly from gun.
2. Uncoil hose and connect one
end to gun. Use two
wrenches to tighten securely
3. Connect other end of hose
to sprayer.
4. Turn OFF power switch.
5. Turn Pressure Control
Knob all the way left
(counter-clockwise) to minimum
pressure.
Prime and Flush Storage Fluid
Before you use your sprayer for the first time or begin a
new spraying project, you need to prime the sprayer and
flush the storage fluid out of the sprayer.
Oil- or Water-based Materials
1. Make sure the power switch is OFF
and the sprayer is unplugged.
If hose is already connected, make sure
connections are tight.
ti9714a
ti9681a
ti9674a
WLD
ti9344a
• When spraying water-based materials, flush
the system thoroughly with water.
• When spraying oil-based materials, flush the
system thoroughly with mineral spirits or com-
patible, oil-based flushing solvent.
• To spray water-based materials after spray-
ing oil-based materials, flush the system thor-
oughly with water first. The water flowing out of
prime tube should be clear and solvent-free
before you begin spraying the water-based
material.
• To spray oil-based materials after spraying
water-based materials, flush the system thor-
oughly with mineral spirits or a compatible
oil-based flushing solvent first. The solvent
flowing out of the prime tube should not contain
any water.
• When flushing with solvents, ground pail and
gun. Read Grounding and Electric Require-
ments, page 5.
• To avoid fluid splashing back on your skin or
into your eyes, always aim gun at inside wall of
pail.
To Next Page
Loading...
Need help?
General
