EN - 10
1. Remove packaging materials from unit.
2. Remove unit from shipping container.
See Move Unit Manually on page 17.
3. Cut packaging ties and discard.
4. Lift discharge chute up slightly and rotate
to operating position. See Figure 3.
5. Check tire pressures (see Check Tire
Pressure on page 22) and inflate to
recommended pressures (see
Specifications on page 39).
6. Remove battery from unit and charge.
See Charge Battery on page 24.
7. Check engine oil level and add oil if
needed. Refer to engine manual.
8. Check hydraulic oil level. See Check
Hydraulic System on page 20.
9. Make sure deck is level. See Level and
Pitch Mower Deck on page 33.
10. Ensure all hardware is tight.
11. Reinstall battery. See Install Battery on
page 24.
ASSEMBLY
WARNING: Read and
understand the Safety section
before proceeding.
To Next Page
Loading...
Need help?
General
