EasyManuals Logo

Gravely Pro-Walk 36 User Manual

Gravely Pro-Walk 36
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
EN - 24
Clean Battery
1. Clean terminals and battery cable ends
with a wire brush.
2. Coat terminals with dielectric grease or
petroleum jelly.
Install Battery
1. Reinstall battery.
2. Reconnect positive cable and then the
negative cable.
3. Place boot over positive terminal.
4. Reinstall battery bracket and battery
cover and secure with two wing knobs.
CHARGE BATTERY
Check battery with a voltmeter. If battery is
less than 11 volts, charge battery.
NOTICE: DO NOT fast charge. Charging at a
higher rate damages or destroys battery.
ONLY use an automatic charger designed for
use with your battery.
NOTICE: Always follow information provided
on battery by battery manufacturer. Contact
battery manufacturer for details regarding
charging.
1. Remove battery from unit. See Remove
Battery on page 23.
2. Place battery on bench in a well-
ventilated area.
3. Connect positive lead of charger to
positive terminal.
4. Connect negative lead of charger to
negative terminal.
5. Charge battery following battery
manufacturer’s instructions.
6. Reinstall battery. See Install Battery on
page 24.
Jump Starting
Gravely does not recommend jump starting
your unit. Jump-starting can damage engine
and system components. Refer to engine
manual for details.
CHECK FASTENERS
Check for loose hardware and tighten if
necessary.
LUBRICATE UNIT
1. Apply oil to all pivot points and pin
connections.
2. Pump grease into grease fittings.
LUBRICATE CASTER HUBS
See Figure 27.
1. Place unit in service position. See
Service Position on page 18.
2. Pump grease into grease zerks until
grease appears at the top of caster hubs.
LUBRICATE CASTER WHEEL
BEARINGS
See Figure 28.
1. Place unit in service position. See
Service Position on page 18.
2. Support unit so front wheels are off the
ground.
3. Remove wheel from fork.
4. Pump grease into grease zerk until
grease passes through the seal in the
wheel hub.
5. Wipe away excess grease.
6. Reinstall wheel into fork and lower unit to
ground.
Figure 26
1. Wing Knob
2. Battery Cover
3. Battery Bracket
2
3
1
Figure 27

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Gravely Pro-Walk 36 and is the answer not in the manual?

Gravely Pro-Walk 36 Specifications

General IconGeneral
BrandGravely
ModelPro-Walk 36
CategoryLawn Mower
LanguageEnglish

Related product manuals