Gree VERSATI III Series Service Manual

Installation
Notes
(a) Distance between indoor unit and water tank should not exceed 5m levelly and 3m vertically. If
higher, please contact with us. Water tank on lower and main unit on higher side is recommended.
(b) Prepare the materials according to the above joints dimension. If cut-off valve is installed outside
the room, PPR pipe is recommended to avoid freeze damage.
(c) Waterway pipelines can‘t be installed until water heater unit is fixed. Do not let dust and other
sundries enter into pipeline system during installation of connection pipes.
(d) After connection of all waterway pipelines, perform leakage test firstly. After that, perform heat
preservation of waterway system; meanwhile, pay more attention to valves and pipe joints. Ensure
enough thickness of insulated cotton. If necessary, install heating device for pipeline to prevent the
pipeline from freezing.
(e) Hot water supplied from insulated water tank depends on pressure of water tap, so there must be
supply of tap water.
(f) During using, the cut-off valve of cooling water inlet of water tank should be kept normally on.
4.8 Request of water quality
Paramete
Parametric value
Unit
pH( 25°C)
6.8~8.0
Cloudy
1
NTU
Chloride
50
mg/L
Fluoride
1
mg/L
Iron
0.3
mg/L
Sulphate
50
mg/L
SiO
2
30
mg/L
Hardness(count CaCO
3
)
70
mg/L
Nitrate(count N)
10
mg/L
Conductance(25°C)
300
μs/cm
Ammonia (count N)
0.5
mg/L
Alkalinity(count CaCO
3
)
50
mg/L
Sulfid
Cannot be detected
mg/L
Oxygen consumption
3
mg/L
Natrium
150
mg/L

Gree VERSATI III Series Specifications

General

Type	Air to Water Heat Pump
Series	VERSATI III
Refrigerant	R32
Operating Temperature Range (Cooling)	10°C to 48°C
Heating Capacity	4.0 - 16.0 kW
Cooling Capacity	4.0 - 14.0 kW
COP	Up to 4.5 (A7/W35)
EER	3.2 - 4.3
Power Supply	220-240V, 50Hz