63 / 72
Click "Interactive IO", send an instruction arbitrarily, and the computer and the oscilloscope will
communicate.
Double-click to open the host computer software, and "Connected" is displayed in the lower left corner
of the interface. At this point, the host computer has been connected.
5. Troubleshooting
1. If the oscilloscope does not start up at power on, follow these steps:
1) Check the power cord to verify it has been connected properly;
2) Check the power on/off button to ensure it has been pushed;
3) Then restart the oscilloscope.
Contact your local HANTEK distributor or directly keep touch with HANTEK Technical Support
department if the oscilloscope still can not be turned on normally.
To Next Page
Loading...
Need help?
General
