6 - Maintenance
6.4
10 hours service - In-Line filter
Unscrew the filter bowl on the in-line filters to inspect and clean the
filter. When reassembling, the O-ring should be greased.
Alternative filter meshes are available. See section on Technical
specifications - Filters and nozzles.
10 hours service - Nozzle filters (if equipped)
Check and clean.
10 hours service - Spraying circuit
Fill with clean water, operate all functions and check for leaks using higher spray pressure than normal. Check nozzle spray
patterns visually using clean water.
50 hours service - Transmission shaft
Check function and condition of the transmission shaft protection guard. Replace possible damaged parts.
50 hours service - Wheel bolts and nuts
Tighten wheel bolts and nuts as follows with following torque wrench
settings:
Wheel hub to rim plate: 160 Ft/lb (215 Nm)
Tightening sequence: See illustration and tighten in order of
numbering.
To Next Page
Loading...
