35
The control panel is splashproof and has a small operating voltage. The panel can be installed in the
washing or dressing room, or in the living quarters. If the panel is installed in the sauna room, it must be
at the minimum safety distance from the heater and at a maximum height of one metre (1m) from the
floor. Conductor tubing (ø 30mm) inside the wall structure allows you to thread the data cable hidden
within the wall – otherwise the installation will have to be on the wall surface. If the control panel is
exposed to water splashes, flush mounting is recommended. The existing Xenio control panel can be
replaced with Xenio WiFi panel without an electrician (» table 1a, compatible devices).
Install the control panel in a location with a good WiFi connection. You can ensure an adequate
WiFi connection with your phone:
> Disable mobile data on your phone.
> Turn on your phone’s WiFi.
> The WiFi connection at the installation location is adequate if the WiFi connection of your phone is
good and other applications that require data transfer work properly.
If the connection is not adequate:
> Try another location.
> If possible, change the location of your WiFi base station so that the connection to the Xenio WiFi
control panel is better.
Building structure, building materials, flush mounting and other similar issues may reduce the
quality of the WiFi connection.
Tip! A WiFi network extender can be used to enhance the network reach.
1. INSTRUCTIONS FOR INSTALLATION
To Next Page
Loading...
Need help?
General
