Pomona, CA Clemmons, NC Nashville, TN
Tel: 908-351-5400 www.haywardpool.com
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
16
*#/Ab#&+%$!#/!Q./+A:%$!Q.&+A&B!a!"#(A+AQ.!"/.((,/.
Q.&+!(AbA&B
Vent pipe diameter must match the vent pipe diameter on the heater (see Table 9). The vent pipe must be
Heatfab single or double-wall stainless steel sealed vent as listed in Table 9. Double-wall vent must be used
in non-conditioned spaces. The maximum total length of vent pipe, and number of 90-degree elbows cannot
exceed the limits specified in Table 8.
7KHYHQWLQJV\VWHPPXVWEHLQVWDOOHGLQDFFRUGDQFHZLWKWKHYHQWPDQXIDFWXUHU¶V+HDWIDELQVWDOODWLRQLQ-
VWUXFWLRQVDQGJXLGHOLQHV7KHLQVWDOOHULVXUJHGWRYLVLW+HDWIDE¶VZHEVLWHZZZKHDWIDEFRPDQGUHYLHZWKH
installation information for Saf-T Vent EZ-Seal (single-wall) and/or Saf-T Vent CI Plus (double-wall) prod-
ucts.
Q.&+!+./9A&%+A#&
The vent system must terminate with a vent terminal approved for this pool heater. Termination may be either
horizontal or vertical. See Table 9 for the Heatfab vent terminals which are approved.
#-+%A&A&B!Q.&+!"A".!%&'!+./9A&%$(
Hayward offers a variety of double-wall vent components, including terminals, elbows, and straight lengths,
which will satisfy the needs of most applications. The available parts are listed in the service parts section in
the back of this manual. Also, Hayward publishes an instruction sheet which can be used as a guide in speci-
I\LQJLQVWDOODWLRQ,WFDQEHREWDLQHGRQ+D\ZDUG¶VZHEVLWHDWZZZKD\ZDUGQHWFRP,I\RXQHHGPRUHVSH-
cialized fittings, you may order them directly from Heatfab, or from an authorized Heatfab dealer. To locate a
dealer for Heatfab venting parts, contact Heatfab at:
Selkirk Corporation
Heatfab Division
130 Industrial Blvd
Turners Falls, MA 01376
(800) 772-0739
www.heatfab.com
&OGS;C!?F!K2N
^;TC;;!.ES?ZJ
9Dd>GOG!Q;@=!">P;!
$;@T=L!!
_L?C>e?@=DE!7!R;C=><DE`
# W#&N;
! W#&N;
% _#&N;
" "#&N;
+DSE;!f
9Dd>GOG!Q;@=!">P;!$;@T=L!D@^!&OGS;C!?F!.ES?ZJ!F?C!!
"?J>=>R;N"C;JJOC;!Q;@=!([J=;GJ