Pomona, CA Clemmons, NC Nashville, TN
Tel: 908-351-5400 www.haywardpool.com
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
35
5HPRYHWKH´SLSHQLSSOHDQGUHSODFHWKH
´SLSHSOXJ,ISURSHUSUHVVXUHFDQQRWEH
achieved by adjusting the gas valve regula-
tor, the installer must contact the gas sup-
plier and request that the inlet pressure to
the heater be set to within the gas pressure
range shown in Table 15.
WARNING EXPLOSION HAZARD: *DVSUHVVXUHVLQH[FHVVRIWKRVHOLVWHGLQ
)LJFRXOGFDXVHDJDVOHDNRUGLDSKUDJPUXSWXUH*DVOHDNDJHFRXOGFDXVHDQ
explosion resulting in severe injury or death.
V%+./!"/.((,/.!(VA+:*!+.(+!)!%'g,(+9.&+!"/#:.',/.]
The pressure switch is preset at the factory for most typical, deck level installations. When the heater is located
above or below the level of the pool or spa, the pressure switch may require adjustment to compensate for the change
LQVWDWLFKHDGSUHVVXUH7KHIROORZLQJSURFHGXUHLVUHFRPPHQGHGZKHQWKHVZLWFKQHHGVDGMXVWPHQWDQGRULVUHSODFHG
For Installations with Heater Above Water Level:
%HVXUHWKH¿OWHULVFOHDQEHIRUHPDNLQJWKHDGMXVWPHQW
7XUQ³21´WKH¿OWHUSXPSDQGHQVXUHDOODLULVRXWRIWKHZDWHUOLQHVDQGHQVXUHZDWHUÀRZUDWHLVDW
least the rated minimum (see Table 14).
7XUQ³21´WKHKHDWHUDQGDGMXVWWKHWKHUPRVWDWWRFUHDWHDFDOOIRUKHDW
4. If the heater does not light, adjust the pressure switch by turning the adjustment knob on the pressure
switch counter-clockwise, until the heater lights. Turning the adjustment knob counterclockwise
decreases the pressure needed to close the switch.
&KHFNWKHIXQFWLRQRIWKHSUHVVXUHVZLWFKE\WXUQLQJWKH¿OWHUSXPSRQDQGRIIVHYHUDOWLPHV7KHSRRO
heater should turn off immediately when the pump is turned off. Never allow the heater to operate with
OHVVWKDQWKHPLQLPXPUDWHGZDWHUÀRZUDWH
For Installations with Heater Below Water Level:
%HVXUHWKH¿OWHULVFOHDQEHIRUHPDNLQJWKHDGMXVWPHQW
7XUQ³21´WKH¿OWHUSXPSDQGHQVXUHDOODLULVRXWRIWKHZDWHUOLQHVDQGHQVXUHZDWHUÀRZUDWHLVDW
least the rated minimum (see Table 14).
7XUQ³21´WKHKHDWHUDQGDGMXVWWKHWKHUPRVWDWWRFUHDWHDFDOOIRUKHDW
4. Turn the adjustment knob on the pressure switch clockwise, until the heater turns off, then turn the knob
óWXUQFRXQWHUFORFNZLVHVRWKDWWKHKHDWHUWXUQVEDFNRQ7XUQLQJWKHDGMXVWPHQWNQREFORFNZLVH
increases the pressure needed to close the switch.
&KHFNWKHIXQFWLRQRIWKHSUHVVXUHVZLWFKE\WXUQLQJWKH¿OWHUSXPSRQDQGRIIVHYHUDOWLPHV7KHSRRO
heater should turn off immediately when the pump is turned off. Never allow the heater to operate with
OHVVWKDQWKHPLQLPXPUDWHGZDWHUÀRZUDWH
+V#N("..'!",9"]
In a few cases the pressure from a two-speed pump is below the 1- pound minimum required to operate the wa-
ter pressure switch on the heater. This is apparent when the pressure switch cannot be further adjusted. In these cases
the pump must be run at high speed to operate the heater. If the pump and piping arrangement are such that the re-
TXLUHGSRXQGPLQLPXPSUHVVXUHFDQQRWEHREWDLQHGGRQRWDWWHPSWWRRSHUDWHWKHKHDWHU&RUUHFWWKHLQVWDOODWLRQ
7DEOH&RUUHFWJDVSUHVVXUHV
Pressure, in. w.c.
FDN FDP
Fuel
Natural Propane
Manifold
´´ZF ´´ZF
Inlet, minimum
´ZF ´ZF
Inlet, maximum
´ZF ´ZF