Hettich MIKRO 185 User Manual

EN
16/38 Rev. 02 / 11.2022 AB1203EN_SA
16 Entering centrifugation parameters
16.1 Direct input of the centrifugation parameters
The speed (RPM), the relative centrifugal force (RCF), the centrifuging radius (RAD) and the runtime can be input
directly with the keys
without previously having to press the
SELECT
key.
The set centrifugation parameters are only stored after starting the centrifugation run.
16.1.1 Speed (RPM)
Example:
RCF
 Press the key to activate the RPM display
(RPM) as needed.
t/min:s RPM >RCF<

RPM/RCF
 Set the desired value with the keys.
t/min:s RPM >RCF<
16.1.2 Relative centrifugal force (RCF) and centrifugal radius (RAD)
Example:
RCF
 Press the key to activate the RCF display
( RCF ) as needed.
t/min:s RPM >RCF<

RPM/RCF
 Set the desired RCF value with the keys.
t/min:s RPM >RCF<

t
 Set the desired centrifuging radius with
the keys as needed.
t/min:s RPM >RCF<
t/min:s RPM >RCF<
16.1.3 Runtime
Up to 1 minute, the runtime can be set in steps of 1 second, and starting from 1 minute, it can only be set in
steps of 1 minute.
In order to set the continuous run, the parameters t/min and t/sec must be set to zero. In the time display
(t/min:s), "--:--" appears.
Example:
t/min:s RPM >RCF<
Example:
t
 Set the desired value with the keys.
t/min:s RPM >RCF<

Hettich MIKRO 185 Specifications

General

Brand	Hettich
Model	MIKRO 185
Category	Laboratory Equipment
Language	English