User Manual of Network Camera
111
Chapter 8 People Counting
Compared with the people counting function supported by the iDS camera, the people
counting of the non-iDS do not need to configure the calibrations, and the parameter
configuration is easier.
Steps
：
People Counting Configuration
1. Enter the People Counting Configuration interface: Configuration >
Advanced Configuration > People Counting
Figure 8-1 People Counting Configuration
2. Select People Counting Configuration tab to set the detailed parameters.
3. Check the checkbox of Enable People Counting to enable the function.
4. Click Draw Area to define the area you want to count the entered people and
left people. Draw area by left click four end-points in the live view window,
and right click to finish the area drawing.
5. Click Entering Direction to draw the entering direction. Adjust the direction
by dragging the two red points on the arrow.
Note:
Click Delete to delete the current drawn area and entering direction.
To Next Page
Loading...
Need help?
General
