User Manual of Network Camera
127
11.9 RS-485 Settings
Purpose:
The RS-485 serial port is used to control the PTZ of the camera. The configuring of
the PTZ parameters should be done before you control the PTZ unit.
Steps:
1. Enter RS-485 Port Setting interface:
Configuration> Advanced Configuration> System > RS485
Figure 11-17 RS-485 Settings
2. Set the RS-485 parameters and click Save to save the settings.
By default, the Baud Rate is set as 9600 bps, the Data Bit is 8, the stop bit is 1 and
the Parity and Flow Control is None.
Note: The Baud Rate, PTZ Protocol and PTZ Address parameters should be
exactly the same as the PTZ camera parameters.
11.10 Service Settings
Go to Configuration> Advanced Configuration> System > Service to enter the
service settings interface.
Service settings refer to the hardware service the camera supports, and it varies
according to the different cameras.
For the cameras support IR LED, ABF (Auto Back Focus), Auto Defog, or Status
LED, you can go to the hardware service, and select to enable or disable the
corresponding service according to the actual demands.
To Next Page
Loading...
Need help?
General
