User Manual of Network Camera
80
Figure 6-50 Face Detection Interface
Steps:
1. Enter the face detection settings interface: Configuration > Advanced
Configuration > Events > Face Detection
2. Check the Enable Face Detection to checkbox to enable the function.
3. (Optional)You can check the Enable Dynamic Analysis for Face Detection
checkbox if you want the face detected get marked with rectangle in the live
view.
Note: Select disable the rules from Configuration-Local Configuration-Live
View Parameters-Rules if you don’t want the detected face marked with the
green frame.
4. Configure the sensitivity [1~5] of the face detection.
To Next Page
Loading...
Need help?
General
