5 Inch Network High-definition Speed Dome User Manual
25
Chapter 4 Access to Network Speed Dome
Note: This chapter has described the configuration for the network speed dome through IE or client software.
There are several network parameters of the network speed dome that need to be set after the hardware installation. Those parameters
including IP address, subnet mask and port number, etc. can be set through various kinds of methods, two methods of which are
introduced as below.
1. Set the network speed dome parameters such as IP address and PPPOE through IE.
2. Set the network speed dome parameters through the client software.
Please make sure that the PC and network speed dome are correctly connected and network connection is established successfully
before the configuration. Two different ways of connection are showed as Figure 4.1 and Figure 4.2.
Figure 4.1 Straight Line Connection Figure 4.2 Crossover Line Connection
4.1Access through IE
When the network connection between the dome and PC has been successfully established, open IE browser and input the IP address
of dome (e.g., 192.0.0.64). The system will remind you to install the ActiveX control. Click and install the ActiveX control.
The system will display the warning message as shown in Figure 4.1.1.
Note: If the ActiveX control installation is blocked by the related software in PC, the following warning message will appear, as show
in Figure 4.1.1. Click Yes to install the ActiveX control.
To Next Page
Loading...
Need help?
General
