User Manual of DS-7000HI-S Series Net DVR
Page 43
5.3 Unit Name and Device ID
Unit name
In the “Display” menu:
There is an item named “Unit Name”. The default unit name is “Embedded Net DVR”. Move
“Active Frame” to unit name edit box, press[EDIT]key to enter edit status, you can modify the
unit name. Please refer to chapter 3.4 about how to input characters. Press[ENTER]key to finish
modification. Select “Confirm” button and press[ENTER], you can save the new unit name and
make it into effect. Press “Cancel” button or[ESC]key to abort modification.
Device ID:
When you use IR remote control to operate DVR, you must use device ID to select DVR.
The default device ID of DVR is “88”. If there are more than one DVR in one place, please define
different device ID for each DVR. Otherwise, the IR remote control will control all DVR with the
same device ID at the same time.
In “Display” menu, move “Active Frame” to the device ID edit box, in the edit status, you
can use numeric keys to input new device ID. The device ID value is ranged among 01-100.
After you finish the modification, press “Confirm” button to save and take effect or press
“Cancel” to abort modification.
To Next Page
Loading...
Need help?
General