Figure 6-5 NAT
2.
Turn on Enable.
3.
Select Mapping Type as Manual or Auto
Auto The port mapping items are read-only, and the external ports are set by the router
automacally. You can click Refresh to get the latest status of the port mapping.
Manual Select an external port type. Click to edit External Port. You can use the default
external port No., or change it according to actual requirements. External Port
indicates the port No. for port mapping in the router.
The value of the RTSP port No. should be 554 or between 1024 and 65535, while
the value of the other ports should be between 1 and 65535 and the value must be
dierent from each other. If mulple devices are congured for the UPnP™ sengs
under the same router, the value of the port No. for each device should be unique.
4.
Set the virtual server of your router, including internal source port, external source port, etc. The
virtual server parameters shall be corresponding with your device port.
6.2.5 Wi-Fi
For certain models, aer installing a Wi-Fi dongle to your device, the device would be able to
connect to a wireless network, and the channels in your device can be viewed thorough Wi-Fi. For
example, if your device is connected with several network cameras or analog cameras (Wi-Fi
network cameras currently cannot be connected),
aer the device is connected to a wireless
network, you would be able to access your device and view the connected channels through Wi-Fi.
Before You Start
●
Prepare a suitable Wi-Fi dongle, and insert it in to the USB interface at the rear panel.
●
Ensure your device support this
funcon.
Steps
1.
Go to Conguraon → Network → General → Wi-Fi .
Digital Video Recorder User Manual
42
To Next Page
Loading...
Need help?
General