HIKVISION DS-96064NI-I16 User Manual

Network Video Recorder User Manual
22
Troubleshooting
Make sure you have installed batteries properly in the remote control. And you have to aim the
remote control at the IR receiver in the front panel.
If there is no response after you press any button on the remote, follow the procedure below to
troubleshoot.
Go to System > General by operating the front control panel or the mouse.
Check and remember device ID#. The default ID# is 255. This ID# is valid for all the IR remote
controls.
Press the DEV button on the remote control.
Enter the device ID# you set in step 2.
Press the ENTER button on the remote.
Checks checkbox
Play or pause video in Playback mode
Advance video a single frame in single-frame Playback mode
Stop/start auto switch in auto-switch mode
13
PTZ
Enter PTZ Control mode
14
ESC
Go back to previous screen
N/A
15
RESERV
ED
Reserved
16
F1
Select all items on a list
N/A
Switch between play and reverse play in Playback mode
17
PTZ
Control
Adjust PTZ camera iris, focus, and zoom
18
F2
Cycle through tab pages
Switch between channels in Synchronous Playback mode

HIKVISION DS-96064NI-I16 Specifications

General

Brand	HIKVISION
Model	DS-96064NI-I16
Category	Network Hardware
Language	English