Network Video Recorder User Manual
43
Configure the Video Parameters
Purpose:
You can customize the image parameters including the brightness, contrast, saturation for the
live view and recording effect.
Go to Camera > Display.
Select the camera from the drop-down list.
Adjust the slider or click on the up/down arrow to set the value of the brightness, contrast or
saturation.
Click Apply to save the settings.
Configure the Day/Night Switch
The camera can be set to day, night or auto switch mode according to the surrounding
illumination conditions.
Go to Camera > Display.
Select the camera from the drop-down list.
Select the day/night switch mode to Day, Night, Auto or Auto-Switch.
Auto: The camera switches between the day mode and the night mode according to the
illumination automatically.
The sensitivity ranges from 0 to 7, and the higher sensitivity results in the more easily to trigger
the mode switch.
The switch time refers to the interval time between the day/night switch. You can set it from 5
sec to 120 sec.
Auto-Switch: The camera switches the day mode and the night mode according to the start
time and end time you set.
Click the Apply to save the settings.
Configure IP Camera Time Sync
The device can automatically synchronize the time of connected IP camera after enabling this
function.
Go to Camera > Camera > IP Camera.
Position the cursor on the window of the IP camera and click .
Check Enable IP Camera Time Sync.
To Next Page
Loading...
Need help?
General
