Mobile Video Recorder User Manual
30
Chapter 7 Camera Management
7.1 Configure Encoding Parameters
Configure encoding parameters to adjust live view image and video parameters.
Go to Configuration → Video/Audio → Video.
● In good network situation, you can set high resolution and bitrate to improve image quality.
● In bad network situation, you can set low resolution, bitrate, and frame rate to get fluent image.
● In bad network situation, if you want to guarantee the resolution, you can set low bitrate and
frame rate to get fluent image.
Stream Type
Main Stream is used for HD storage and live view. Sub Stream is used for BD storage and live
view when the network bandwidth is insufficient.
Video Type
If you want to record both video and audio, select Video&Audio. If you just want to record
video, select Video Stream.
Resolution
The higher the resolution, the clearer the image, and the higher the requirement of network
bandwidth.
Bitrate Type
You can select Variable or Constant.
Video Quality
If the bitrate is variable, you can select video quality according to your needs. The higher the
video quality, the higher the requirement of network bandwidth.
Frame Rate
The higher the frame rate, the higher the requirement of network bandwidth, and the higher
the needed storage capacity.
Max. Bitrate
If the bitrate is variable, enter the max. bitrate. The bitrate will change automatically below the
max. value.
Video Encoding
Select H.265 (only supported by some models) or H.264 according to the actual needs.
To Next Page
Loading...
Need help?
General