Network Traffic Camera • User Manual
76
5) Select Capture Interval type between time and distance, and set the interval time or
interval distance.
6) Set Speed Limit Sign according to actual speed value on speed restriction board, and
it will be overlaid on captured picture.
7) Set Speed Limit for Truck. When the truck speed exceeds the set speed limit, capture
will be triggered.
8) Set Min. Speed for Truck. When the truck speed exceeds the set min. speed, capture
will be triggered.
9) Select the linkage flashlight output.
Usually one lane is linked to one flashlight. If you link more than one flashlight, you need to select
Flashlight Mode. Simultaneous flash and sequential flash are selectable.
(Optional) Copy the configuration of current lane to other lanes.
Click Save to save the settings.
You can click the Default to restore the parameters to default values.
RS-485 Radar
If high accuracy speed detection is required, you can select the trigger mode as RS-485 Radar.
Go to Configuration > Device Configuration > Application Mode.
Select Application Mode as RS-485 Radar.
To Next Page
Loading...
Need help?
General
