HIKVISION iDS-TCV907-BER User Manual

Chapter 4 Record and Capture
4.1 Set Storage Path
4.1.1 Set Storage Card
If you want to store the les to the storage card, make sure you insert and format the storage card
in advance.
Before You Start
Insert the storage card to the device.
Steps
1.
Go to
Conguraon → Storage → Storage Management → HDD Management → HDD Storage .
Figure 4-1 Set Storage Card
2.
Format the storage card in two ways.
-
Check the storage card, and click Format to format it manually.
Note
For the newly installed storage card, you need to format it manually before using it normally.
-
If you want to format the storage card automacally when the card is abnormal, enable Auto-
Inialize Redundant Storage.
Note
If you enable Auto-Inialize Redundant Storage, reboot the device to take the sengs into
eect.
3.
Oponal: If the device has been connected to the plaorm, and you want to upload the storage
card informaon automacally, enable Auto-Upload Data in Redundant Storage and set the
interval.
4.
Click Save.
Network Trac Camera Operaon Manual
13

HIKVISION iDS-TCV907-BER Specifications

General

Brand	HIKVISION
Model	iDS-TCV907-BER
Category	Security Camera
Language	English