Hirschmann RSPE 30 User Manual

36
Installation RSPE 30/32/35/37
Release 12 10/2015
2.3 Mounting a dummy panel or a media module
Hirschmann supplies the RSPE 30/32/35/37 device with free, uncovered
media module slots.
2.3.1 Mounting a dummy panel
If you do not use media modules, close the slots with dummy panels, that you
obtain as an accessory, in order to keep the degree of protection.
See “Accessories” on page 63.
Proceed as follows:
 Place the dummy panel onto the media module slot of the device.
 Fasten the dummy panel to the device by tightening the 2 screws.
2.3.2 Mounting a media module
Hirschmann supplies the media modules ready for operation.
The media modules provide restricted hot-swap-capability. You have the
option of mounting the media modules while the device is operating. To start
the operation, it is necessary to restart the device.
Proceed as follows:
 Remove the dummy panel (if mounted) from the media module slot on the
device.
 Insert the media module into the slot on the device.
 Fasten the media module to the device by tightening the 2 screws.
 Restart the device.

Hirschmann RSPE 30 Specifications

General

Brand	Hirschmann
Model	RSPE 30
Category	Switch
Language	English