Hisun Motors VECTOR 500 User Manual

OPERATING THE VEHICLE 8-2
CAUTION：
To avoid personal injury:
 Always use the seat belts when operating
and riding the vehicle.
Adjust the seat belts for proper fit and connect the
buckle. This seat belt is an auto-locking retractable
type.
① Seat belt
2. Selecting light switch position.
■ Head Light Switch
Turn on the key switch and turn the head light
switch to the “ON” position.
Turn the head light switch to the “OFF” position to
turn off the head light.
① Head light switch
② Head lights “OFF”
③ Dipped headlight “ON”;
④ Headlights on full beam “ON”;
⑤ 4WD button
⑥ 2WD button
NOTE：
Turning the head light switch to the “ON” position
causes the following lamps to light simultaneously.
1. Tail lights (lamps at the rear portions of the
vehicle)
2. Lamp built in the coolant temperature gauge
3. Lamp built in the fuel gauge
4. Lamp built in the speedometer
■ Hazard Light Switch
[if equipped]
Press the top half of the hazard light switch, the
hazard light flash along with the indicator on the
instrument panel. Press the bottom half of the
hazard light switch to turn off the hazard light.
Note:
 The hazard light switch is operative when the
key switch is in the “ON” or “OFF” position.
Be careful that keeping the switch “ON”
causes the battery to run out.
■ Turn Signal Light Switch
[if equipped]
To indicate a right turn, turn the turn signal light
switch clockwise.
To indicate a left turn, turn the turn signal light
switch using the arrow point to left. Use the right
facing arrow for indicating right turns
When the left or right signal is activated, the
indicated turning light will flash and the other will
stay on.
The indicator lamp at the instrument panel also
flashes like the above.
NOTE:
 The turn signal light switch is only operative
when the key switch is in the “ON” position.

Hisun Motors VECTOR 500 Specifications

General

Brand	Hisun Motors
Model	VECTOR 500
Category	Utility Vehicle
Language	English