Hisun Motors VECTOR 500 User Manual

PERIODIC SERVICE 11-9
IMPORTANT
When the fuel line is disconnected for maintenance
or repair close both ends of the fuel line with a
piece of clean cloth or paper to prevent dust and
dirt from entering in, care must be taken not to
allow dust and dirt into the fuel pump. Even a small
amount of dust or dirt can cause premature wear
and malfunction of the fuel pump and injector
components.
① fuel pump ② fuel line
③ Exit pipe
■ Checking battery condition
DANGER
If do not use or charge the refillable type
battery, you must replace new battery.
CAUTION
To avoid personal injury
 Never remove the battery while the engine
is running.
 Keep electrolyte away from eyes, hands
and clothes. If you are spattered with it,
wash it away completely with water
immediately and get medical attention.
 Wear eye protection and rubber gloves
when working around the battery.
The factory –installed battery is non-refillable type
if the battery is weak, charge the battery or
replace it with new one
◆ Battery charging
CAUTION
To avoid personal injury
 When the battery is being activated,
hydrogen and oxygen gases in the battery
are extremely explosive. Keep open sparks
and flames away from the battery at all
times, especially when charging the
battery.
 When disconnecting the cable from the
battery start with the negative terminal first;
when connection the cable to the battery
start with the positive terminal first.
 Always check battery charge by using a
voltmeter.
① Battery
1. To slow charge the battery connect the battery
positive terminal to the charger positive
terminal and the negative to the negative.
Then recharge using the instructions on your
charger.
2. A boost charge is only for emergencies it will
partially charge the battery.
3. When exchanging an old battery for a new one
use battery of equal specification shown in
table 1.

Hisun Motors VECTOR 500 Specifications

General

Brand	Hisun Motors
Model	VECTOR 500
Category	Utility Vehicle
Language	English