Hisun Motors VECTOR 500 User Manual

OPERATING THE VEHICLE 8-3
If the hazard light switch is pressed to the
“ON” position while the turn signal is activated,
the indicated turning light will flash and other
will stay on.
 Be sure to return switch to center position after
turning.
① Head light ② Head turn signal lamp;
③ Tail turn signal lamp
3. Checking the brake pedal.
■ Brake Pedal
CAUTION:
To avoid personal injury:
 If the operator suddenly brakes, an
accident may occur due to loss of control
or shifting forward of heavy loads.
 When driving on icy, wet or loose surface,
make sure the vehicle is correctly balanced
to avoid skidding or loss of steering
control. Reduce the speed.
The brake pedal is the left pedal on the foot board.
Depress the pedal to slow or stop the vehicle.
① Brake pedal
4. Selecting the travel speed.
■ Gear Shift Lever
CAUTION:
To avoid personal injury:
 Avoid changing gear shift lever when
ascending or descending a slope.
 Before ascending or descending a slope,
shift to the “L” position to control the
vehicle speed.
 If you shift gears while ascending or
descending a slope, be prepared to use the
brake to maintain control.
 Operate in reverse at slow speeds to
maintain control.
1. The gear shift lever can be shifted only when
vehicle is completely stopped and the speed
control pedal is in the “NEUTRAL” position.
2. To avoid transmission and shift linkage
damage, completely stop the vehicle using the
brake pedal before shifting gears.
3. Select proper gear and engine speed
depending on the type of job.
4. Before dismounting vehicle, shift the gear shift
lever to the “NEUTRAL” position and set
parking brake.

Hisun Motors VECTOR 500 Specifications

General

Brand	Hisun Motors
Model	VECTOR 500
Category	Utility Vehicle
Language	English