Hisun Motors VECTOR 500 User Manual

PERIODIC SERVICE 11-3
DAILY CHECK
For your own safety and maximum service life of
the vehicle, make a thorough daily inspection
before operating the vehicle or starting the engine.
CAUTION
To avoid personal injury:
 Be sure to check and service the vehicle
on a flat surface with the engine off and the
parking brake “ON”.
■ Walk Around Inspection
Look around and under the vehicle for such items
as loose bolts, trash build-up, oil or coolant leaks,
broken or worn parts
■ Checking and Refueling
CAUTION
To avoid personal injury:
 Do not smoke while refueling.
 Be sure to stop the engine before refueling.
1. Turn the key switch to “ON”, check the amount
of fuel by fuel gauge
2. Fill fuel tank when fuel gauge shows1/4 or less
fuel in tank.
① Fuel tank cap
Fuel tank capacity
29L（7.6 U.S.GALS.）
IMPORTANT
If oil level is low, do not run engine.
Checking engine oil level
1. Park the vehicle on a flat surface, raise the
cargo bed, mount the safety support and shut
off engine.
2. To check the oil level, unscrew and remove
the dipstick, wipe it clean, replace it, and draw
it out again, check to see if the level is too low,
add new oil to the prescribed level at the oil
inlet.
① Oil Level
② Oil inlet
③ Dipstick
④ Cap
IMPOTTANT
If oil level is low, do not run engine
■ Checking Coolant Level
CAUTION
TO avoid personal injury
 Do not remove radiator cap while coolant
is hot. When cool, slowly rotate to the first
stop and allow sufficient time for excess
pressure to escape before removing the
cap completely.
1. Park the vehicle on a flat surface, raise the
cargo bed .mount, the safety support and shut
off the engine.

Hisun Motors VECTOR 500 Specifications

General

Brand	Hisun Motors
Model	VECTOR 500
Category	Utility Vehicle
Language	English