Hisun Motors VECTOR 500 User Manual

PERIODIC SERVICE 11-6
① joint boot ② Drive shaft
① Joint boot ② Drive shaft
■ Checking tire inflation pressure
Though the tire pressure is factory-set to the
prescribed level, it naturally drops slowly in the
course of time, thus check it every day and inflate
as necessary.
tire sizes
inflation pressure
Front & Rear: 26x10-12
70kPa (0.7kgf/cm2, 10psi)
EVERY 50 HOURS
■ Greasing
Apply a small amount of multi-purpose grease to
the following points every 50 hours. If you operated
the vehicle in extremely wet and muddy conditions
lubricate grease fittings more often.
① Parking brake pedal
② Parking brake pivot(spray type grease)
① Range gear shift lever pivot (spray type grease )
■ Checking engine start system
CAUTION
TO avoid personal injury
 Do not allow anyone near the vehicle while
testing.
 If the vehicle does not pass the test, do not
operate the vehicle.

Hisun Motors VECTOR 500 Specifications

General

Brand	Hisun Motors
Model	VECTOR 500
Category	Utility Vehicle
Language	English