Hitachi CIW03-H User Manual

16. Temperature Range Restriction
34
A16381TMF2
16. Temperature Range Restriction
The temperature range can be set by the wired remote controller.
1. Set Temperature Range
Step1. Select "Service Menu" on the Service & Installation screen
and press "OK".
Step2. Select "Temperature Range Restriction" and press "OK".
Step3. Select "Lower Limit for Cooling Operation" or "Upper Limit
for Heating Operation" and press "OK".
Step4. Press " ", " ", " ", or " " to select the setting value.
Step5. After value setting, s elect "
OK
" and press "OK" . Press " " to
return to Step3.
NOTES:
•
Please make sure that the upper limit value is equal to or greater than the lower limit value.
•
Please make sure that the upper heating limit is set equal to or greater than the lower heating limit.
•
Dierent indoor and outdoor units have dierent temperature ranges.
•
When Cool/Heat Auto Changeover is eective, the upper and lower limit for auto heating/cooling is displayed
in "Temperature Range Restriction". Please set the upper limit greater than the lower limit.
When using two wired remote controllers, the auto upper and lower limit are not synchronized. Please set
them with the own wired remote controllers.
•
When Dual Setpoint is eective, the upper and lower limit for dual setpoint is displayed in "Temperature
Range Restriction". Please set the upper limit greater than the lower limit.
When using two wired remote controllers, the auto upper and lower limit are not synchronized. Please set
them with the own wired remote controllers. Please note that the temperature setting is "cooling setting
temperature ≥ heating setting temperature +2
o
C(3
o
F)".
Upper/Lower Limit for Cooling
Set the upper limit larger than the lower limit. Back
Upper Limit Lower Limit
86°F 64°F
OK
17. Dual Setpoint Setting
The setting allows you set the temperature of cooling and heating individually.
To use this function, refer to the Item b8 (Page 10 ) to enable auto function in function selection.
1. Set Dual Setpoint
Step1. Select "Service Menu" on the Service & Installation screen
and press "OK".
Step2. Select "Dual Setpoint" and press "OK".
Step3. Press " " or " " to select "ON" or "OFF".
Step4. Press "OK" to confirm the setting.
Step5. Press " " to return to Step2.
OK
Select Back
Dual Setpoint
ON
OFF
Conference Room
Cool Fan Speed LouverTemp Menu
78
A/C
Sav: Low | Main
78
F
18. Main/Sub Display Setting
The main or sub display of the remote controller can be turned o.
1. Set the main/sub display invisible.
Step1. Select "Service Menu" on the Service & Installation screen
and press "OK".
Step2. Select "Main/Sub Display" and press "OK".
Step3. Press " ", " ", " ", or " " to select "Not Display".
Step4. Press "OK" to confirm the setting.
Step5. Press " " to return to Step2.
With Priority Setting No Priority Setting
Main
No icon
Sub

Hitachi CIW03-H Specifications

General

Brand	Hitachi
Model	CIW03-H
Category	Remote Control
Language	English