5-13
Slightly position the bucket teeth downward (0 to 10 degrees)
and dig the ground while driving the machine forward as de
-
scribed below. Always take care not to apply loads to only to
one side of the bucket.
1. Position the bucket teeth slightly downward.
2. While driving the machine forward, tilt the bucket so that
the ground surface is gradually separated.
3. Adjust the digging depth by operating the lift arm.
4. Drive the machine with the bucket tilted backward fully
and held at the lowest possible position.
M4GB-05-007
M4GB-05-008
M4GB-05-009
M4GB-05-010
To Next Page
Loading...
Need help?
General
